Cooling System Repairs in Shoreham-by-Sea
Radiator repairs, thermostat replacement, water pump services and coolant flushes to keep your engine running at the right temperature.
Radiator repairs, thermostat replacement, water pump services and coolant flushes to keep your engine running at the right temperature.
Your engine's cooling system works hard to maintain the right operating temperature. When something goes wrong, whether it's a leaking radiator, a stuck thermostat, or a failing water pump, your engine can overheat quickly. Left unchecked, overheating causes serious and expensive damage including blown head gaskets and warped cylinder heads.
At A Star Garage we carry out full cooling system diagnostics and repairs on all makes and models. That includes radiator repair and replacement, thermostat replacement, water pump fitting, coolant hose replacement, and complete coolant flushes. We use quality parts and the correct coolant specification for your vehicle.
If your temperature gauge is creeping up, your heater isn't blowing hot, or you've spotted coolant under the car, bring it in and we'll find the problem. Early diagnosis saves you money and keeps your engine safe.
The most common causes of overheating are low coolant level, a faulty thermostat, a failing water pump, or a radiator leak. Any of these can prevent your engine from cooling properly and should be checked as soon as possible.
Most manufacturers recommend changing your coolant every 2 to 3 years, but always check your vehicle handbook for the specific interval. Old coolant loses its protective properties and can lead to corrosion inside the cooling system.
No. If your temperature warning light comes on, pull over as soon as it is safe to do so and switch off the engine. Continuing to drive risks serious engine damage including a blown head gasket or warped cylinder head.
A radiator replacement typically takes between 2 and 4 hours depending on the vehicle. Some models require more disassembly to access the radiator, which can add time.
A coolant flush involves draining all the old coolant from your system, flushing it through with clean water to remove any debris or buildup, and then refilling with fresh coolant to the correct concentration.